AUDIOLINE WAVE 10X Informacje Techniczne Pobierz pdf (Strona 18)

2. Insert the IBM Enhanced Diagnostics backup diskette

into diskette drive A.

3. Power-on all attached devices; then, power-on on the

server.

4. Follow the instructions on the screen.

Power-On Self-Test (POST) Messages

If you receive an error message during the power-on

self-test (POST), completing the steps outlined in this

section might enable you to resolve the problem.

Note

If you have just added, removed, or changed the

location of a device and you receive an error

message, you must reconfigure the server.

1. Write down all error code numbers and descriptions

that appear on the screen as you start the server.

(Note that a single problem can cause several error

messages to appear. When you correct the cause of

the first error message, the other error messages

probably will not appear on the screen the next time

that you power-on the server.)

2. If you have set a power-on password and have the

password prompt set to On or Dual, a password

prompt appears. If you have set both power-on and

administrator passwords, you can type either of the

passwords at the password prompt. However, if you

think you might need to change any settings in the

Configuration/Setup Utility program, you must type the

administrator password at the password prompt. If

you type the power-on password, you will be able to

view the error codes and error code descriptions that

are displayed on the POST Startup Errors screen;

you will also be able to view limited information in the

Configuration/Setup Utility program. However, you

will not be able to change any settings.

3. In the case of most errors, the Configuration/Setup

Utility program starts automatically so that you can

attempt to identify and correct the problem. When the

Configuration/Setup Utility program starts, a screen

titled POST Startup Errors appears. (Note that the

POST Startup Errors screen does not appear

immediately. You must wait approximately one

minute.)

4. At the POST Startup Errors screen, select Continue

if you want to access the Configuration/Setup Utility

program menu. Select Exit Setup if you want to exit

from the Configuration/Setup Utility program. (For

more information on exiting from the

Configuration/Setup Utility program, go to the

Attention: section that follows step 5d on page 11.)

10 IBM Netfinity Servers HMM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 151 152

Komentarze do niniejszej Instrukcji

Brak uwag

AUDIOLINE WAVE 10X Informacje Techniczne Strona 18

Komentarze do niniejszej Instrukcji