AUDIOLINE WAVE 10X Informacje Techniczne Pobierz pdf (Strona 71)

Ethernet Controller Operation Mode

Switch

When you want to change the Ethernet controller operation

mode from Normal to MAC Disabled, you must change the

setting of configuration switch 6.

1. Locate the configuration switches on the system

board. For more information, refer to the label inside

the server, or see “System Board” on page 96.

2. To set the Ethernet controller operation mode to the

appropriate value, set switch 6 as shown in the

following illustration. It might be helpful to use the

end of a small screwdriver to set the switch.

Note: In the following illustration, MAC represents

media access control. This refers to the

Ethernet controller address.

Ethernet Normal Operation Ethernet MAC Disabled

12345678 12345678

ON ON

OFF OFF

3. Move the switch to the ON position.

4. Make the required adjustments to the Ethernet

controller address.

5. Move the switch back to the OFF position.

6. After changing configuration switch settings, you must

reconfigure the server. After reassembling the server

(see “Completing the Installation” on page 56), use

the Configuration/Setup Utility program to reconfigure

the server. For more information, see

“Configuration/Setup Utility Program Menus” on

page 19.

IBM Netfinity 3500 - Type 8644

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 151 152

Brak uwag

AUDIOLINE WAVE 10X Informacje Techniczne Strona 71